mga paps baka may makatulong sa inyo.
Tama ba pagkakaintindi ko na dapat per device ang assignment ng ipv6 kung naka enable sa lahat? Hindi kasi nakakakuha ng ipv6 bawat device na naka connect sa network ko. Currently ganito setup ko and naka enable yung ipv6 sa main router at AX3
Is this a multi-wan setup / load balancing? And you use your ER605 as your gateway / router? Then I think you should use your Huawei as an access point only, meaning your client devices are in the same 192.168.0.0/24 subnet, DHCP on the AX3 is disabled, and it is connected to LAN instead of WAN. So you can avoid Double-NAT and make IPv6 work, because your Huawei AX3 only gets a /64 and it cannot split /64's.
You can probably set your ER605 to assign /60 subnets though, so your ax3 can assign v6 /64 addresses if you want to separate the main router from the AX3 access point. My approach is kinda different tho, my main router is the one that does different subnets, giving sub-networks (guest and main lan) their own v4 and v6 subnets.
Anyways, assuming you have proper bridge mode (so your router can get a /56 prefix), yes you can have IPv6 in every client device you have when you have at least one ISP with IPv6 support. My setup has PLDT main and Globe secondary with no IPv6, and my clients have IPv6 despite that.
Here is my setup in detail.
mga paps baka may makatulong sa inyo.
Tama ba pagkakaintindi ko na dapat per device ang assignment ng ipv6 kung naka enable sa lahat? Hindi kasi nakakakuha ng ipv6 bawat device na naka connect sa network ko. Currently ganito setup ko and naka enable yung ipv6 sa main router at AX3
have you checked tha manual of your multi-wan router? i don't know how you setup your multi-wan, but unlike ipv4, ipv6 is propagated upwards -- i.e. in ipv4 you can have multiple 192.168.1.100 NATed IPs since the upstream doesn't care about your internal IP config, but in ipv6 everything is global, so if your multi-wan ISP both have ipv6, downstream clients will have 2 ipv6s assigned (one per ISP) as with this, multi-wan ipv6 on a non-static IP is quite difficult, since you need to set a static route to which ISP the ipv6 traffic goes thru.
as with @wlangtitibag setup, I have 4 connections (let's call it having 4ISPs all having ipv4 and ipv6)
what I did was a simple partition (via vlans), I only use 2ipv6 out of the 4isp, one is propagated to all the devices connected, and another is propagated to a separate network, the 4ipv4 ips are also partitioned but 2 are on multi-wan (aggregated, next-hop setup) to almost all devices, 1 is set to work devices, and the last one is for jack sparrows (also having it's own ipv6 network)
PING 1.1.1.1 (1.1.1.1): 56 data bytes
64 bytes from 1.1.1.1: icmp_seq=0 ttl=55 time=167.707 ms
64 bytes from 1.1.1.1: icmp_seq=1 ttl=55 time=168.938 ms
64 bytes from 1.1.1.1: icmp_seq=2 ttl=55 time=168.122 ms
64 bytes from 1.1.1.1: icmp_seq=3 ttl=55 time=233.554 ms
64 bytes from 1.1.1.1: icmp_seq=4 ttl=55 time=169.215 ms
64 bytes from 1.1.1.1: icmp_seq=5 ttl=55 time=184.701 ms
^C
--- 1.1.1.1 ping statistics ---
6 packets transmitted, 6 packets received, 0.0% packet loss
round-trip min/avg/max/stddev = 167.707/182.040/233.554/23.791 ms
1 <1 ms <1 ms <1 ms 192.168.1.2
2 2 ms 2 ms 2 ms 100.83.0.1
3 887 ms 1033 ms 1061 ms 122.2.203.6.static.pldt.net [122.2.203.6]
4 3 ms 1 ms 1 ms 210.213.130.13.static.pldt.net [210.213.130.13]
5 26 ms 25 ms 25 ms 210.213.130.103.static.pldt.net [210.213.130.103]
6 1214 ms 1256 ms 1159 ms 10gigabitethernet1-15.core1.hkg1.he.net [74.82.46.121]
7 83 ms 85 ms 85 ms 100ge10-1.core1.tyo1.he.net [184.105.64.130]
8 166 ms 167 ms 168 ms 100ge11-1.core1.sea1.he.net [184.105.213.117]
9 199 ms 204 ms 200 ms 100ge1-2.core1.msp1.he.net [184.104.194.22]
10 208 ms 207 ms 207 ms 100ge13-1.core2.chi1.he.net [184.105.223.177]
11 227 ms 227 ms 225 ms 100ge1-2.core1.nyc4.he.net [184.104.193.174]
12 * * * Request timed out.
13 * * * Request timed out.
14 * * * Request timed out.
15 * * * Request timed out.
16 * * * Request timed out.
17 1292 ms 1299 ms 1339 ms 104.236.69.55
Thanks xrampage. Parang hindi practical this pandemic kasi ang daming pumapasok na tao. Yan kasi reklamo nung kakilala ko, pldt fibr kasi sya. Now after nung inspection parang may nakitang hindi ok so baka may babalik na naman to fix the installation. Ang hassle esp na pandemic pa din.
In my case, nagrerestart ang modem ko about 5-7 times per day.
Not sure kung connection or hardware issue.
I'm thinking requesting pldt to replace the modem/router, but not sure what model has better processor, and bigger flash/ram.
meron po bang naglalaro ng CS:GO dito? Sobrang jerky ng movements at unplayable pero ok naman ung ping at walang packet loss kaso unstable ung tick rate from 10ms upto 200ms
Hello po, biglang nagkaproblema ako sa ping noong nag-LOS yung modem namin noong mga October 21. Yung mga server (Singapore, Hong Kong, Tokyo, etc.) na dapat mababa lang yung ping biglang naging 1k+.
Sa Apex, ito yung itsura ng server list ko, at pag triny kong maglaro, paminsan-minsan lang ako nakakakuha ng server na maayos yung ping. Mostly 1k+ yung nararanasan ko:
Sa Valorant, kahit Hong Kong yung pinili kong server, at kahit nakasabi na 33 lang yung ping ko doon, pagpasok ko sa game, over 900 yung ping ko palagi:
May nakaranas na ba po ng ganitong problema, or may nakakaalam ba po kung ano po yung nanyayari? Gusto ko po kasing itawag ito sa PLDT bukas or imessage sila thru FB or Twitter, pero di ko po alam kung problema ba nila ito or sa amin yung may problema. Hindi ko rin po alam kung ano yung dapat irequest sa kanila other than sabihin sa kanila na biglang tumaas yung latency sa mga games.
^Nangyari sakin yan sa CS:GO mababa ung ping pero jerky ung movements pag maglalakad at changing of weapons pero sa Dota 2 maayos naman ung ping at walang packet loss itry ko mag download ng Apex legends at tingnan ko kung may ping spikes
Edit: Wala rin problema sa Apex Legends sa CS:GO lng talaga may problem
I just noticed - the site is currently offering 60Mbps for their Asenso Fibr Plan 2099, but their regular home Unli Fibr Plan 2099 is just 50Mbps. Is there anything stopping people from getting that one? I didn't see any business permit requirements. Mas ok pa for faster customer support and guaranteed uptime.
Or could this be a sign we're getting another adjustment soon? :>
getting the same issue with csgo and valorant, sometimes lag din sa dota 2. noticed that latency spiking up when the game is running. I know for a fact that it is not a problem with my pc or the game itself since i have no issue with my other provider
I just noticed - the site is currently offering 60Mbps for their Asenso Fibr Plan 2099, but their regular home Unli Fibr Plan 2099 is just 50Mbps. Is there anything stopping people from getting that one? I didn't see any business permit requirements. Mas ok pa for faster customer support and guaranteed uptime.
Or could this be a sign we're getting another adjustment soon? :>
You will be required to send the business permit in order for your line application to be approved.
Sa CSGO server side yung issue afaik. Unplayble lang yung Deathmatch mode dahil may matinding rubberbanding. Other modes like Competitive are unaffected. Wala naman akong lag pag ibang games like Pubg, Apex, o Dota
@GerEdc22
good to know hindi to problem sa side ko pinaghinalaan ko na tuloy ung 3rd party router ko na meron ng issue pero kahit nakarekta ung lan cable ko sa PLDT ONU ganun parin ung problema
