Hi Techs..
Hopeless na ba to? I\'ve checked if there are loose objects inside pero wala talaga ako makita.. kahit pieces of paper na nakasingit wala.
I searched for fixes online pero lahat ng nakikita ko para sa purge counter lang..
Help please??
Unit: BROTHER J220
Error: Init.48 / Print.48
Thanks!
Edmund
Forum Topic
Brother MFC-J220 Init.48 ERROR
-
up ko ito same problem
-
up din to..same problem as mine
-
brother mfc & dcp error code and solutions
By Alfred Valencia on Saturday, September 7, 2013 at 3:41pm
These are list of brother printer error codes, cause and possible solutions for Brother Inkjet Printer DCP and MFC Series. These error codes mean machine problems. In many cases, the machine will require service.
Please refer to the following table to check the error code displayed on the LCD.
Error Code
Cause
Solution
30,31,32,33,34,35,36 37,38,39,3C,3F
The machine does not work due to a paper jam.
Clear the paper jam
40,42,43,44
The internal temperature is too high.
Unplug the machine from the AC outlet and if possible cool the room where the machine is located.
46
The ink absorber pad is full and needs replacing.
Replace Waste Ink Absorber pad then perform this procedure forDCP Model or MFC Model
48
There is a problem on the print head,
Please contact Brother Customer Service.
49
The internal temperature is too low.
Unplug the machine from the AC outlet and if possible warm the room where the machine is located.
4F
There is a problem on the print head.
Please contact Brother Customer Service
50,51,52,57,5A,5B,5C,5D 5E,6C,6F,70,71,72,73,7A 7D
The machine does not work due to a paper jam or some sensor problem.
Clear the paper jam. If the problem still continues after clearing the paper jam, try to clean the encoder strip behind theprinter head
8F
There is a problem on the paper feed motor.
Replace paper feed motor
A5,A6,A7,A8,AF
There is a problem on the scanner.
Please contact Brother Customer Service
E2,E3
There is a problem on the main PCB.
Replace PCB Mainboard
This Reset Procedure is for Brother MFC Series Printer
Problem: Brother MFC Printer display \"unable to clean\" or Error 46 Solution:
First turn of the printer
Switch on the machine while holding down the “menu” button until all the leds are flashing on/off. Now you are in “maintenance” mode.
Press 80
Press the “mono start” button several times until you see “purge: xxxx”
Press “2783” in order to reset the purge counter. You will see: “purge:0000”
Press the \"stop\" button.
Press “99” to exit the maintenance mode. -
palitin n po ung printer head nyan mga sir
-
Pwede pa ba ma-repair MFC-J200 printer head? Looking for any one who can repair