Edit: Sorry for too many typos, im using a cheap lumia phone :)
Natanong ko to dahil gusto kong malaman kung niloloko na ba ko ng shop na pinagbilhan, and now hinihingian ng warranty.
The item in question is a high end mobo. After assembling the pc, nagboot ang pc, nagamit ko pa to for browsing, installing for about 2 days. After that, i decided to install additional rams - so from 8gb, i added 2 4gb sticks, for the total of 16gb. These are the same brand. The 4 rams came in kit.
Now, the pc wont boot. However if i remove the 1 stick of ram in this certain ram slot, the pc boots. Of course to test whether it was ram issue, i tried each stick ome at a time at a working ram slot. When i tried putting one stick on one specific ram slot. It wont boot.
Now i ask you, is it a defevtive ram slot or not? Since the mobo is 2 weeks old, dinala ko siya sa shop for warranty. Dinala ko rin buong unit ko to demonstrate ung issue, same result sa shop, after long argument on some minor things na sinisilip nila for excuse, naconvibce ko sila na there\'s a problem with the mobo. Nakita naman nila e, nag boot kapag walang ram ung isang specific slot.
So the tech started disassembling the pc to extract the mobo. As usual he thouroughly inspected it to assure there was no disqualification for warranty. For pullout na daw un ng supplier. After 10 days, i called for an update, and to my surprise, meron daw bent pin si mobo. Un mismong lagayan ng proc. Sabi ko, kung may bent pin yan, di yan mag booboot.
So tama ba? Pwede pa rin bang magboot ang pc kahit may bent pin na ininstallan ng proc?
E bakit nangyayari ung sa ram slot issue above? Di kaya nilloloko nako ng mga to para maka-iwas sa replacement since mahal ung board at rare pa. (x99 board). At saka pano kaya maproprove kung sino naka-bend nun?
Help! Nakakaiyak ginastos ko dito. :(
-- edited by Alpha_13 on Nov 20 2014, 09:04 PM
Forum Topic
how likely is it for a pc to boot where the mobo gas bent pin but correctly installed proc.
-
mobo lang ba sir yung oina RMA mo or Mobo with procie na?
kung mobo lang, sino ang nag pull out ng mobo sa case at ng procie sa mobo? kung sila dapat nakita na nila agad yan
yes, pwede pa din mag boot yan as long as sakto or tama ang pag contact ng pin ng mobo sa contact ng procie
saka sir tsek mo na lang din yung documentation (manual) ng mobo, merong list ng incompatible RAM dun, tsek mo sir baka lang di compatible sa isat isa yung mga ram mo -
Mobo lang. Mobo lang galing sa kanila.
Yes sila nag pull ng proc from mobo
Regarding compatibilty, malalaman nila gad un dahil isa rin un sa grounds na tinitingnan ng shops to devoid warranty. And yes, siyempre naman po chineck ko kung compatible o hindi, besides ang konti pa lang ng ddr4 rams na as of now e all made compatible to x99 boards. -
i-insist mo sir, sila ang nag alis ng procie sa mobo, kung talagang kaw ang may kasalanan ng bent na yan, dapat dun pa lang nakita na nila yan ng ininspect nila yung item, di mo na kasalanan kung nag ka bent yan, kahit saan ka makaratin, mali nila yan, kung masipag ka nga pwede mo i-DTI yan
-
baka yung bent pin na yun isa sa mga pins ng bus patungo sa memory socket. so posible yun. di lang yan mag magboot kung yung pin patungo sa northbridge
-
Hi Sir,
Tanong ko lang ano nangyari sa Board nyo? napalitan ba?
Meron din ako High End Mobo with Bent Pins, 3years ko nagamit tpos 1day bigla nlang hindi gumagana. dun sa LED Code ng Board nkalagay Code 55 which means "No Memory Found" so I think same issue ung Mobo natin.
Na confirm ko na working pa yung dalawang Memory ko kasi gamit ko ngayon sa isa kong unit, nag punta ako sa Store na pinagbilhan ko ipapa RMA ko sana kaso nakita nila na may Bent Pins na.. so ma vovoid daw yung warranty. naghahanap ako ngayon Service Center na pwede mag check ng Bent Pins bka kaya nila ibalik sa dati before ko itry ipa RMA ulet.