Sa mga nagkakaproblema sa pag configure ng Baudtec modem nila for use with an external wifi router
On your Baudtec modem/router
Step 1: Set to 1483 Bridged
Step 2: Set to DHCP: NONE
Step 3:
Disable Routing -
ito yung dahilan kaya hindi pa rin nagkakaron ng DHCP IP addresses yung external router nyo after doing steps 1 and 2
Step 4: Disable wireless on Baudtec
Step 5: Export configuration to file (browser will download "config.img" file)
Step 6: Save all changes and reboot Baudtec
On your PC connected to Baudtec (after doing step 6 above)
Step 1: pull up a command prompt or DOS prompt
Step 2: type
ipconfig /release and then press enter key
Step 3: type
ipconfig /renew and then press enter key
Step 3: Pakitingnan ang detalye to make sure you are getting a public IP address thru the Baudtec modem, meaning it is not 192.168.x.x
At this point you may not be able to connect to the Baudtec via the 192.168.1.1 address - huwag magpanic, ok lang yan kasi configured na yung Baudtec. Kung may kelangan ka baguhin later on, reset mo to factory default yung Baudtec, then import mo yung config file na nabanggit sa taas, then make your changes and save-export config mo uli.
Watch this tube video kasi pareho ng steps, magkaiba lang yung interface
<click here for link>
Next step mo is to configure your wifi router to get external IP address from Baudtec and to configure DHCP/wifi settings as well.
-- edited by De_Leon on Nov 29 2015, 12:43 AM
