Forum Topic

Converge ICT Fiber ISP Thread (never ever hard reset your modem and refer to page 1 for FAQs)

  • @oweneighty
    try mo yung mesh ng tenda. kasing presyo lng dn ng newifi ang 2pack. sure buong bahay sakop yan
  • For peeps inquiring on how to set a bridged port in Huawei EG8245H5:

    1. Backup existing configuration
    >> Go to Advanced > Maintenance Diagnosis > Configuration File Management.
    >> Click on Download Configuration File and save the XML file that will be generated.

    2. Unassociate LAN port/s from routed ports
    >> Go to Advanced > WAN.
    >> Click on "2_INTERNET_R_VID_10" (the VID 10 and connection entry number may vary depending on area).
    >> At "Binding Options:", uncheck a LAN port (don't unbind them all at the same time to avoid risk of losing management access to ONU).
    >> Click apply.

    3. Create bridge port configuration
    >> Go to Advanced > WAN.
    >> Click on New.
    >> Under "WAN Mode:", select "Bridge WAN".
    >> For "VLAN ID:", copy the same VLAN ID used in the "2_INTERNET_R_VID_10". In my case my VLAN is 10.
    >> For other parameters
    >>> Enable WAN checked
    >>> Encapsulation Mode IPoE
    >>> Protocol Type: IPv4 (can be changed incase Converge rolls out IPv6)
    >>> Enable VLAN checked
    >>> 802.1p stuff are left as is
    >>> Multicast VLAN ID left as is
    >> In "Binding Options:", check the LAN port you previously unassociated in "2_INTERNET_R_VID_10". In my configuration, I unchecked LAN4 port in "2_INTERNET_R_VID_10", and checked it here for the bridge port.
    >> Click Apply.

    4. Disable ONU DHCP
    >> Go to Advanced > LAN > DHCP Server
    >> Under Primary Address Pool, uncheck "Enable Primary DHCP Server:". If there's a secondary DHCP server configured in the ONU as well, uncheck that also.
    >> Click Apply.

    5. Verifying new WAN Configuration
    >> In Advanced > WAN, there should be a new connection entry. In my case it's "3_INTERNET_B_VID_10".
    >> VLAN IDs should be the same for the route WAN connection and bridge WAN connection.
    >> Connect a device, set as DHCP, to the LAN port configured for bridge from step 3.
    >> Device should be able to get IP address from Converge.

    6. Save and backup new configuration
    >> Go to Advanced > Maintenance Diagnosis > Configuration File Management.
    >> Under "Save Configurations and Reset", click on the Save button.
    >> Click on Download Configuration File. Preferably save the new backup config file under a new name/different directory so as not to override the backup file done in step 1.

    Miscellaneous:
    - Set either the ONU LAN IP, or your routing device of your choice in separate private IP subnets.
    - For accessing ONU web management behind bridged port:
    -- One option is to set the routing device WAN interface-facing IP to within the same subnet as ONU LAN IP's.
    -- Another is to create a sub-interface for the WAN facing interface of your routing device, and do NAT masquerading or SNAT rule when destination is ONU LAN IP.

    For reference, this is how my bridge port configuration looks like: <click here for link>

    This is how my ASUS RT-AC66U_B1 services_start JFFS script looks like to enable access to ONU web management through a bridged port:
    <click here for link>

    -- edited by Ominous on Dec 10 2020, 03:19 AM
  • @Ominous

    Pareho po tayo ng modem so I want to follow your instructions. Pero sa umpisa pa lang, may mali na sa side ko.

    Under BACKUP EXISTING CONFIGURATION, sa second part na ise-save yung XML file, wala pong DOWNLOAD CONFIGURATION FILE sa akin. There are only two buttons: SAVE and then SAVE AND RESTART. So I can't do this option.

    Baka siguro dahil naa-access mo yung superadmin config. Sa akin kasi, hindi ko mapasok yung superadmin. Pano po ba?

    -- edited by AaronICK on May 16 2020, 12:08 PM
  • anu po advantage ng naka bridge port? naka Huawei EG8245H po ako.. salamat
  • Baka siguro dahil naa-access mo yung superadmin config. Sa akin kasi, hindi ko mapasok yung superadmin. Pano po ba?

    @AaronICK

    I used the credentials in page 1. If it doesn't work for your ONU, welp can't help with that. ¯\_(°_o)_/¯
  • @Ominious

    Ay gumana po yung sa password sa page 1!

    Ano po yung pipiliin ko sa apat? OLT, EMS, ACS or ON THE ONT WEB PAGE?

    -- edited by AaronICK on May 16 2020, 12:49 PM
  • may naka encounter ng "resolving host" when browsing?
    how to fix it?
    thanks!
  • may naka encounter ng "resolving host" when browsing?
    how to fix it?
    thanks!


    Try mu set ka ng DNS sa gadget mu mismo
  • Ano po yung pipiliin ko sa apat? OLT, EMS, ACS or ON THE ONT WEB PAGE?

    @AaronICK
    I think yung ONT WEB PAGE iseselect.
  • paano po palabasin ang bridge mode sa zte f660?

    -- edited by peejhaymakots on May 16 2020, 10:01 PM
  • Tanong ko lang kung biglang bumagal ba streaming sa Twitch lately? Plus mataas na ping sa CODMW tipong 150+ but around 30ms lang sa dota2. TIA
  • yup twitch almost 2 weeks na, kahit 160p buffering
  • @ominous Thanks for the bridge mode guide. Is there any side effect on the connection when setup as bridge mode? Also do you how to setup ddns like asus ddns?

    -- edited by snicky11 on May 17 2020, 01:00 AM
  • @Ominous

    OK na sir. Salamat sa turo mo. Na-bridge mode ko na yung modem. Bale naka-connect na ang gamit kong router sa LAN4 ng converge modem.

    Ang napansin ko lang po, after ko gawin ang bridge mode, hindi ko na ma-access ang converge config page. Kailangan ko pa ibalik sa LAN1 yung LAN cable para ma-access ko ulit yung converge config page.

    Is there a way na ma-access pa rin ang converge config page kahit na naka-bridge mode na?

    Thanks in advance sa sagot po...

    -- edited by AaronICK on May 17 2020, 10:33 AM
  • Hi to all

    Ask ko lang

    Isu-submit ko sana receipt na binayad ko sa 7-11 na 4000 for initial cash out. Mag papa-install kasi ako ng 25 Mbps - 1500 Php. Pag ka bayad ko naka received ako na natanggap na raw ng converge. bali ang ginamit ko na proof of payment ay ayun kasi nawala ko yung resibo nag punta ako sa 7-11 para humingi ulit pero need daw ng manager kaso wala daw bukas pa daw ng 9 AM. kaya ang ginamit ko muna at sinend ko sa converge sa website nila ay yun natanggap ko through text.

    May makakasagot ba? Salamat in advance.


    UPDATE

    Nagawan ko ng paraan kahit wala pa yung manager ng 7-11 sa store. pinahanap ko sa cashier kahit di siya marunong mag kalikot nagawa niya ng maayos. Salamat ng sobra. Naipasa ko na kay Converge through website yung receipt.

    -- edited by SpagMeatBalls on May 17 2020, 01:22 PM
  • @SpagMeatBalls

    Kung tatanggapin ng converge yung text, then OK na. Pero kung hindi, then kailangan mong may ipakitang resibo sa kanila.

    Advice ko lang po sa inyo: ALWAYS KEEP A SOFTCOPY OF YOUR RECEIPT at wag na wag po ninyong iwawala ang resibo. You will never know, baka magkaroon ka ng issue later on sa billing at payment. Kung may softcopy kang nakatago sa cellphone mo or PC< then may proof of payment kang maipapakita.

    Ako, simula ng nagpakabit ako ng converge, lahat ng resibo ko (I pay online via my BPI bank account), may screenshot ako ng online receipt. Lahat yun naka-compile dito sa PC ko. Minsan akong nagkaroon ng issue sa converge, may proof agad akong nai-send sa kanila kaya nakaiwas ako sa malaking abala.
  • For those who have f660 you can use DMZ host and static IP to act like bridge which makes everything fast when you have another router. If some knows the proper way to bridge mod please inform us ^^
  • mabilis ang speed sa speedtest or any type of speedtest website and also for browsing and downloads, but when it comes to online games parang cod warzone mataas ang ping around 150-200 lagi and also for twitch kahit low qual lang nag bbuff parin, any of you encountering the same issue?
  • ^Nasa Asia Server ka ba sa cod warzone?
  • ^ console po kasi ako sir eh so hindi siya parang dun sa PC na nakaka pili ka kung saan ka mag coconnect, naka LAN na din po ako pero ganyan padin yung ping
  • use vpn with sg server tapos ang problema mo, 42ms with no packet loss.
  • Post deleted #12299912
  • ^okay po sana kaso need pa mag avail ng vpn plan, as far as i know walang vpn na free for use for consoles
  • Dun sa mga may problema sa Socialclub at Rockstar games (GTAV etc.), all you need to do is to turn off your router para magiba ang IP niyo.

    Do note though, na sa amin, kailangan overnight patayin para mabago IP. Hindi nagana yung 5 mins tas bukas ulit, di magbabago IP mo. Kailangan matagal. I suggest overnight pagmatutulog na kayo. Sakin kinabukasan nagiba na IP ko, and hindi na blocked socialclub.
  • Also question lang, meron ba na nag A-ARK dito? Di ako makapagcreate ng server, dahil naka CGNAT. Meron bang way para makagawa ng server na makikita ng outside ng LAN?
  • Post deleted #12299926
  • Post deleted #12299927
  • @rawe
    There are ways like setting up a VPN Server through VPS (Virtual Machine). Gagastos ka nga lang and you would deal with unbearable latency.
    Another way is if sa PC ka naglalaro, I dont if this works with hosting your own server, try using VPNs such as NordVPN, you could try searching cheap VPNs at our well known online shopping store LZD.

    -- edited by cyberakuma on May 17 2020, 08:58 PM
  • not sure if naitanong na pero wala bang violation sa policy ni converge if maglagay ako ng 30m LAN cable papunta sa house ng brother ko which is katapat lang namin? thank you
  • @Ominous

    Yung 2_INTERNET_R_VID_10 ko po walang Binding options na naka check ang meron po is yung 4_INTERNET_R_VID_10.