Forum Topic

The Coolers Thread: CPUs / GPUs / HSFs / Fans: New Products and Reviews

  • Nice new arctic fans, ma try nga palitan stock ng Liquid freezer 240 ko, lalo parating na tag init
    kaso concern lang ako sa case ng liquid freezer, since naka daisy chain siya ok lang kaya max ng 0.29A max ng P12 Max vs 0.1A ng regualr P12


  • ^

    anong balita sa P14 version nyan? Parang goods sana para sa 280/420mm aio
  • planning to retire my 6 x 14cm nocti's kung maglabas ng p14 max... sana maglabas din sila ng variant katulad ng sa pst/pst co's for easier daisy chaining...

    palitan ko na rin siguro yung 2 m25 phanteks ko sa cpu heatsink saka yjng plankng 3 x m25 mahihing p12 max na siguro hahaha...

    wala pa sa ratsada at shakee eh...
  • may p12 max na sa shakee/ratsada... kay dobolyudeekampuuters... 695/699 isa respectively... hahaha... mababa na yan kaysa sa srp na "€12.99"

    wait na lang kayo sa mga shyneese sellers na magbenta at baka bumaba pa...

    -- edited by STASIS on Mar 04 2023, 08:17 PM
  • ^nice pero hindi PST or wala kayang PST to dahil antaas ng power draw? plan ko pa naman palitan yung nasa LF2 240 ko
    Baka need na ng ganito



    -- edited by ViperXtreme on Mar 04 2023, 09:13 PM
  • <click here for link> (di pa rin marunong mag embed ng YT video sa TPC)

    Noise test ng P12 MAX. Mukhang goods pag naayos ung fan curve (or if wala pake sa noise, 3000RPM to sawa).

    -- edited by GENTLEMEN on Mar 04 2023, 09:15 PM
  • @ViperXtreme: or you can just buy 4 pin pwm extender cables... marami rin sa shakee/ratsada ng custom spliiters... 2/3/4... sa case ko daisy chain ng 6 na noctua nf-a14... gamit ko deepcool fh-10 fan hub (10 port)... na nakasaksak sa isang mobo fan header... pero balak kong ibahin kaya gagamit ako ng extender cables para ma control separately yung intake/exhaust...
  • 500+ Php lang siya sa Amaz*n ngayon pero no direct delivery sa Philippines. Baka bumaba pa yung pricing sa official local distro ng Arctic.



    -- edited by Ignus on Mar 06 2023, 04:31 AM
  • @STASIS: so pano diskarte pag sa liquid freezer? 1 cable lang kasi siya, i would assume na yung new P12 Max using the fan hub kabit ko sa CPU lang then the pump is sa CPU pump header ng board?
  • @ViperXtreme
    .29 A na yung rating ng P12 Max from .1 sa old P12, halos 3 times na. Usually 1A yung rating ng motherboard fan header kaya up to 3 P12 Max fans lang ang recommended na isaksak.

    Edit:
    Yung old P12 up 5 yung recommended ng Arctic. Eto yung sa P12 max:



    -- edited by Ignus on Mar 06 2023, 04:24 AM
  • @Ignus: ye gaya ng sa old post ko above, na take account ko din yun baka kaya walang PST version.
  • for more than 1 purchase ng p12 max if ever may kakagat... hintayin ninyo nalang siguro yung value packs nila... kung maglalabas...

    phanteks m25 vs arctic p12max...

    price: 350 ± php / 650 ± php
    fan speed: 500-2000 ± 150 rpm / 200 – 3300 ± rpm
    airflow: 84.26 CFM / 81.04 CFM
    static pressure: 2.67 mm H?O / 4.35 mm H?O
    acoustics: 35.7 dB / 20.63 dB

    pili na... hahaha...
  • @vipe: check mo na lang price difference ng arctic fan hub vs locally available deepcool alternatives (pref. fh-10)
  • @STASIS: iniisip ko kung sapat na 4port hub without the sata power, yung 2x p12max on the cpu 4pin heather then yung pump ng arctic sa dedicated pump heather ng board
  • 240mm nga pala yung sa'yo... using 2x p12max fans... kaya pa yan as what @Ignus has posted... unless mag more than 3 fans ka na gagamitin (push-pull ng 4 p12max's?)... get 4 pin pwm fan splitters sa ratsada/shakee (2-way) or yung 4 port fan hub ni deepcool na walang sata power
  • Scythe Fuma 3 incoming! Out of stock na yung Rev. B sa Amaz*n, baka sa next restock out na :)

    Based lang sa pictures mas mataas yung fin density at yung heatpipes sa rear tower nagbago ng angle para umiwas sa VRM heatsinks.







    -- edited by Ignus on Mar 06 2023, 03:38 PM
  • @STASIS: sa LF2 kasi is 2x fans then yung block fan and then pump, kaya pa siya in 1A assuming full load? maliit lang kaya konsumo ng pump and radial fan?
  • @vipe: kaya pa yan... better check also specs ng fan header ni mobo... pero if in doubt ka talaga... there's no harm naman in using hubs na powered ng sata...
  • @STASIS: Just checked the specs manual and kaya nga, 2A ang max current n CPU_header ko so pagsabayin ko lahat dun kasya pa madami pa headroom hehe, daisy chain ko na lang.
    Maybe they take into account na gagamitan ng 360AIO yung fan header kaya mas mataas current headroom



    -- edited by ViperXtreme on Mar 06 2023, 10:25 PM
  • push-pull mo na yan for 4 na p12max ^^...
  • Hello! I have the Strix B450-F Gaming II mobo. Kaya kaya ng mobo ko mga ports ng Hyperion GR701 na case? Like yung sa front panel port, fans etc?
  • @zurcmit: check both specs ng mobo and case...

    usually for cases... generic naman na maa accommodate lahat ng ports as long as intended ang size niya rito... for your case choice eh supported niya up to e-atx mobo... compatible yan...
  • @STATIS: what I mean is yung port sa harap ng case hehe! Baka lang mas may makapag bigay ng info hindi ako ganun kagaling magbasa ng mga info about that kasi
  • front i/o port/s?


    1 x headphone / Microphone
    4 x USB 3.2Gen1
    1 x USB 3.2 Gen2 Type C
    LED Control Button
    Reset Button
    1 x USB 4.0 Type C or 1 x USB 3.2 Gen 2x2 Type C

    this spec might vary by region


    again... compatibility is to a certain degree... ikakabit mo rin naman yan sa motherboard mo... intuitive naman na ang motherboard manuals na may step/by step guide on how to connect it sa front i/o ports...

    again... cross check your mobo specs with the case... a little elbow grease wouldn't hurt... rule of thumb naman lagi... kung meron sa mobo at meron sa case... ok yan... kung wala... di mo naman magagamit...
  • Scythe Unveils New Kotetsu Mark III CPU Cooler with Upgraded Design and Enhanced Cooling Performance

    Scythe, the renowned Japanese cooling specialist, is all set to launch its latest iteration of Kotetsu CPU coolers, the Mark III.


    <click here for link>
  • oonaakona Send Message View User Items on 03 Mar 23 @ 08:55 AM - click here for link #

    kailagan ko pala lagyan ng top exhaust at intake bottom balak ko na sana palitan ng Lian Li Lancool 216 current case ko.


    Yung bottom sir kahit hindi na, halos minimal lang effect sa cooling. Kahit skip mo na ito. Di din kasi maganda tignan hehe pero yung top, switch ka to mesh filter. Lagyan mo ng 2 exhaust fan. Kulob kasi yung case lalo na pag yung GPU and CPU Cooler halos dikit. Add mo din yung distance nila sa Tempered Glass kaya may hot spot din sa glass.


    nagpalit na ako ng pc case Lian Li Lancool 216 ang pinalit ko so far from 100c GPU Hotspot to 83c (highest)
  • ^

    Diba better pa rin for aircooled GPU na regular mount (not vertical) unless if mesh ung katapat ng gpu fans?
  • Just got the P12 Max, will install and test em later on my LF II 240